Updating sky box software
This can be accessed from the Sky Engineers Menu by doing the following: Press “SERVICES” on your Sky Plus Remote Select Option 4 Next press 0, 1 and SELECT – you should now see the engineer’s menu. The box will now take a few minutes to reset itself.BE WARNED: This will clear your HD and thus wipe all your recorded programs!!e) Now, wait 10 minutes (don't skimp on this) or wait until the lights go out, then turn your Skybox on from the remote.You might need to try the remote a couple of times at this point.
Finding Your Router's Address (Windows) Finding Your Router's Address (Mac) Installing Router Updates Updating an Air Port Router Show 1 more... Questions & Answers Related Articles References This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness.This solution has also been known to resolve pausing and recording issues. ‘back up’ is force software update only, not reset.Take the mains power out of the box, press and hold both left and right arrors on the top of the box and whilst holding plug back into mains, the record light should show at which point you release the left and right and press the centre select.When that happens, press the TV guide to see if it is working. Sometimes, it just happens for no good reason at all.Basically, this resets your hard drive settings and should solve the problem. There's a number of reasons that this happens to your Sky box. The important thing is that you might be under the impression that your Skybox is dead and you need a new one, when that isn't necessarily the case.